PUSH Sports Patella Stabilizer Brace

The pressure pad in the Push Sports Patella Brace applies pressure to the knee tendon and effectively supports the kneecap. As a result, pain around the kneecap is reduced. With each step, the brace applies intermitting pressure to the knee tendon. This results in a comfortable and relieving amount of pressure applied.

If you are experiencing kneecap pain, it is worthwhile to visit a sport physiotherapist or sport physician for a correct diagnosis. 
ARTG No. : 221613

Note: Materials have not been tested against salt or chlorine water, they may wear out quicker than braces not in contact with salt or chlorine water.

Features & Benefits

• Supports the kneecap and applies pressure to the patellar tendon in the event of pain complaints
  
  
• Distributes comfortable pressure to the patellar tendon via anatomically shaped pad
  
  
• Anti-slip pressure pad maintains position on the leg, even during competition
  
  
• Minimal material in the knee cavity for increased comfort
  
  
• Reduces pain during sports
  
  
• Easy on/off application
  
  
• Machine washable on gentle at low temperature

Indications

• Patellar tendonitis (Pain or irritation in the tendon just below the kneecap)

• Jumper’s knee (Pain and inflammation in the tendon below the kneecap caused by repetitive jumping or impact activities.)

• Patellofemoral pain syndrome (Pain around or behind the kneecap)

• Osgood-Schlatter disease (Knee pain caused by irritation where the tendon attaches below the kneecap)

• During sports such as basketball, soccer, or running

• During gym workouts involving squats, lunges, or leg training

• As support during rehabilitation or daily activities

Sizing Guide
One size fits most, fits knee circumferences from approximately 27 cm to 45 cm. It is universal for left and right knee.

Application
Before use: remove the protective foil from the pad.

1. Bend the leg. Place the patella brace on the knee tendon immediately below the kneecap, with the kneecap fitting in the recess.

2. Hold the pad with one hand and use the other hand to wrap the brace around the leg.

3. Close the hook and loop material as tightly as possible, without pinching. If the strap fails to close on the hook and loop material, use the strap's other fastener.